Bronkhorst®
Instruction Manual EL-FLOW® Select9.17.099F 51
Parameter index
Parameters
Parameters - Alarms
Alarm Delay Time 39
Alarm Info 38
Alarm Maximum Limit 39
Alarm Minimum Limit 39
Alarm Mode 38
Alarm New Setpoint 39
Alarm Setpoint Mode 39
Reset Alarm Enable 39
Parameters - Counter
Counter Limit 40
Counter Mode 40
Counter New Setpoint 41
Counter Setpoint Mode 40
Counter Unit 40
Counter Value 40
Reset Counter Enable 41
Parameters - Device identification
BHT Model Number 37
Customer Model 37
Device type 38
Firmware version 37
Identification number 37
Serial Number 37
User Tag 37
Parameters - Fluid set
Capacity 43
Capacity Unit 43
Capacity Unit Type Pressure 44
Capacity Unit Type Temperature 43
Fluid Name 43
Fluid Set Index 43
Parameters - Fluid set (advanced)
Density 44
Fluid Temperature 44
Heat Capacity 44
Inlet Pressure 44
Outlet Pressure 44
Thermal Conductivity 44
Viscosity 44
Parameters - Master/Slave
Master Node 45
Slave Factor 45
Parameters - Measurement and control
Analog Input 37
Fmeasure 36
Fsetpoint 36
Measure 35
Pressure 36
Setpoint 36
Setpoint Slope 36
Temperature 36
Valve Output 37
Parameters - Network configuration
Fieldbus1 Address 42
Fieldbus1 Baud Rate 42
Fieldbus1 Parity 42
Fieldbus2 Address 42
Fieldbus2 Baud Rate 42
Fieldbus2 Parity 42
Parameters - Special
Control Mode 34
Init Reset 34
IO Status 35
Reset 34
Wink 34
To Previous Page
Loading...
