Brother BAS-415 - Adjusting Wire Tension; X-Feed Wire

111 Adjusting wire tension
1. X-feed wire
0
1.5 kg
Using a 1.5 kg torque wrench or a similar tool, push at the location marked by the arrow and adjust so there
is a deflection of approximately 14 mm.
How to adjust
1) Remove the seven screws 0 and the two covers (LR, LL)@.
2) Loosen the two screws 0 of both hook (LX) @) and hook (RX) 0.
3) There are two stoppers (U) (S) on the right and the left sides. Turning them clockwise will increase the
tension and turning them counterclockwise will decrease the tension.
4) When the tension is proper, tighten screw 0.
5) After tightening screw 0, firmly retighten stoppers (U) (S) so there is no looseness.
-17-
From the library of: Superior Sewing Machine & Supply LLC