Brother BAS-415 - Adjusting synchronizer

IDJ Adjusting synchronizer
The synchronizer detects the needle position and synchronizes the motion of the needle and the holder
base.
When the emergency stop operates after the power switch is turned on, or when the machine stops after
thread trimming, the needle bar will be released in the jump condition, and the thread take-up will stop at
the same position as the other 8 needle bars.
1. Adjusting machine stop position (stop signal)
( BAS-411 )
<DSYNCH ®Ov- TRVL
ROM J-Ver. M*, S*
ROM K-Ver. *
( BAS-415 )
+- [SYNC] [TRVEL]-+
J-Ver * K-Ver *
( BAS-411 )
( SYNCH check TDU
( BAS-415 )
)
(_SY_N_C_H· __ T_=_·_D_=_•_U_=_O __ ]
1) Turn on the machine power.
2) (BAS-411)
Press the alphanumeric key <0> key in the main
menu.
(BAS-415)
Press the<*> key in the main menu.
3) (BAS-411)
Press the < 1 > key to select <DSYNCH.
4) The green LED located on the upper right of the
panel will display the numbers from <D to ® as
shown in the figure on the left.
-23-
(BAS-415)
By pressing the < <l> key, select [SYNC].
The circles next to "T" and "D" in the display are
black.
From the library of: Superior Sewing Machine & Supply LLC