(§]
Attaching X
wire
Carriage
1)
Position the carriage in the back, toward the
left
of
the machine, making
sure
it
does
not
move.
2)
Attach the wire end (the end closer
to
the ball)
to
hook
(RX)
0
with
bolt@.
r-"'
3)
Feed
the wire around pulley
@)
from the
left
side,
then under pulley
0.
Then
feed
it
behind pulley @
from the
left
side,
and
over pulley
@).
Then,
feed the wire around pulley & from the left, and finally
wind
it
around pulley@ from the right.
4)
After
winding the wire around pulley@, feed
some
slack
into the wire.
Then, put the
ball on the wire into the hole
of
wire drum
(X)@).
Fit the wire completely
into
the groove, then wind the wire eight times around the wire drum.
5)
Feed
the wire around the back
of
pulley
tiD
I then around pulley m from the left.
6)
Wind the wire
onto
pulley~
from below, then around pulley
@from
the left.
7)
Wind the wire over pulley (I) from above, then around pulley
@from
the left.
Attach the wire
to
hook
(LX)
@
with
bolt
4D.
NOTE:
Be
careful
not
to
scratch the wire.
The
wire
is
coated
with
resin
and a
scratch
may
decrease
its
durability.
-44-
To Next Page
Loading...