Brother BAS-415 - Adjusting thread breakage detect stud

[!] Adjusting thread breakage detect stud
3/4
When the needle thread is pulled near the needle and the thread which moves the thread breakage detect
stud
Ois slowly returned, the thread breakage detect stud 0 should return to its position smoothly. Adjust
the tension by moving shaft no.1@ right or left. _
{Adjust so that the spring moves within 3/4 of the hole@) of the 2-stage thread guide)
NOTE: When #120 thread is used, the needle thread tension should be from 60- 120 g ..
-19-
From the library of: Superior Sewing Machine & Supply LLC