Brother BAS-415 - Page 28

2. Adjusting needle down signal
When the machine pulley 0 is turned in its normal direction and the needle is 5 mm above its lowest
position,
the lit needle down signal should go off. Loosen the two screws@ to adjust.
NOTE 1: When procedure 1 "Adjusting machine stop position" is done, the needle down signal will move to
the same angle. Be sure to adjust the needle down signal when machine stop position has been
adjusted. When only
the needle down signal is adjusted, the machine stop position does not need
to be adjusted.
NOTE 2: How to attach the sewing machine pulley
Rotate the sewing machine in the normal rotation direction. Align the first screw with the screw
stop
of the upper shaft and attach the pulley. Then, tighten the screw.
-25-
From the library of: Superior Sewing Machine & Supply LLC