BES-962BC • BES-1262BC
162
Chapter 6 Embroidering
2. Click [OK] when the items are set.
Manually trim the lower thread immediately after resetting a thread breakage error if feeding by
stitch back is long (i.e., 40 to 50 mm or more) when "After the end of mending" is set to "Non
stop".
Set "When the machine is stopped" to "Trim lower theread only".
Adjust
Adjustment value of the needle is set.
The adjustment value is set at the increment of 0.1 mm.
The setting range is –0.5 ~ 2 mm in X and Y directions.
1. Select [Adjust] from Settings menu.
2. When setting is complete, click [OK].
To Next Page
Loading...
Need help?
General
