Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC
42
2-9 Installation of Software
Use an attached CD-R for installing software. If a personal computer with no CD-R drive unit is
used, connect a drive unit to the computer.
1. Set the CD-R for installation.
Setting the CD-R starts the installation program automatically.
2. Select the language and click "Next".
Note) When the software has already been installed, the following message appears.
[In case this aplication is already installed, please be sure to un-install it.]
Un-install the software.
3. The screen for user registration is displayed. Input your name and department. Click [OK]
after inputting is finished.
4. Check the user information. Click [OK] if the contents are correct.
5. Specify a folder for setup.
6. Click [TO NEXT] to start installation.
7. After setup is properly finished, a message is displayed.
8. Click [OK] to complete installation.
To Next Page
Loading...
Need help?
General
