BES-962BC • BES-1262BC
60
Chapter 3 Embroidering Procedures
Switches at Machine Heads
BES-962BC BES-1262BC
Between head No.1 and No.2
Between head No.3 and No.4
Between head No.5 and No.6
Between head No.2 and No.3
Between head No.4 and No.5
Stop switch
Stops embroidering operation. When embroidering is stopped, flashes.
Refer to "Resetting Machine Stop" ( page 191) to stop flashing.
Start switch
Starts embroidering. Holding down this button executes embroidering at a low speed.
When resuming embroidering after stop switch, release machine stop before
pressing this button. Refer to "Resetting Machine Stop" (
page 191) for details.
Switches on Tension Plate
Start switch
THREAD SENSOR lamp
HEAD switch
MENDING lamp
MENDING switch
STEP BACK/FWD switch
Stop switch
Start switch
Stop switch
To Next Page
Loading...
Need help?
General
