Chapter 11 Error code list
BES-962BC • BES-1262BC
248
Code
E-43
E-A1
E-A2
E-A3
E-A4
E-A5
E-A6
E-A7
E-A8
E-A9
E-B0
E-B1
E-B2
E-B3
E-B4
E-B5
E-B6
E-B7
E-B8
E-B9
E-BA
E-BC
E-BD
E-BE
E-BB, BF
E-C1
E-C2
Error
Slave I/F EEPROM read error
Spindle motor lock
Main PC board temperature too high
Spindle motor voltage too low
Spindle motor voltage too high
Spindle motor CPU error
Spindle motor CPU communication command error
Spindle
motor CPU send/receive error
Spindle
stop position signal error
Spindle CPU parameter error
Lower shaft CPU error
Thread tangle in rotary hook
Hook motor origin point error
Hook motor standby position error
Hook motor motor mode error
Hook motor communication error
Hook motor parameter error
Hook motor overheat error
Hook motor overcurrent error
Thread trimming motor zero point error
Power supply frequency error
No power error
Lower shaft flash memory error
Lower shaft version-up error
Lower shaft motor undefined error
Area over during embroidering
Wiper out error
Measures
Turn the power off and on once. If the same error occurs again, the main
PC is faulty.
Press the
STOP
or turn on the F/B switch on the head to either side. If it
occurs frequently, the main shaft mechanism is faulty.
This is not usually displayed.
Adjust the pulley stop position (100 degrees) above the needle and press
the
STOP
. If the error occurs frequently, the parts related to the main shaft
stop position sensor are faulty.
This is not usually displayed.
Check to see that no lint is tangled in the rotary hook and press the
STOP
or
turn on the F/B switch on the head to either side.
The rotary hook may be rotated forcefully. Press the
STOP
or turn on F/B
switch on the head to either side to cancel the error. If the same error
occurs again, the lower shaft sensor is improperly adjusted.
This is not usually displayed.
Turn the power off and on once. If the same error occurs again, the lower
shaft motor is faulty.
Turn the power off and check the thread trimmer and turn the power on
again. If it occurs again, the thread trimmer is faulty.
Turn the power off and on once. If the same error occurs again, the power
PCB or power supply is faulty.
It may usually occur momentarily when turning off the machine. If it occurs
when the machine is on, it is a power failure detection error.
Turn the power off and on once. If the same error occurs again, the main
PCB is faulty.
Press the
STOP
or turn on the F/B switch on the head to either side to cancel
the error and upgrade the version again.
This is not usually displayed.
Set the embroidering area again on PC.
If the wiper is tangled with a thread, remove it. Press the
STOP
or turn on the
F/B switch on the head to either side.
To Next Page
Loading...
Need help?
General
