Brother DCP-750CW - Page 28

Configuring your machine for a wireless network
21
3
h After a few tens of seconds, you can select the SSID from the list using a or b. Press OK to select the
SSID.
If you select the SSID displayed, go to k.
If you want to add a new SSID, go to i.
i Select <New SSID> using a or b.
Press OK. Go to j.
j Enter the SSID. (For information how to type text, see Entering Text on page 112.)
Press OK. Go to k.
k Using a or b, select Infrastructure when instructed.
Press OK. Go to l
If you select Ad-hoc, go to m.
l Select the Authentication method using a or b, and press OK.
If you select Open System, go to m.
If you select Shared Key, go to n.
If you select WPA/WPA2-PSK, go to q.
m Select the Encryption type, None or WEP using a or b, and press OK.
If you select None, go to s.
If you select WEP, go to n.
n Select the key option; KEY1, KEY2, KEY3, KEY4 using a or b, and press OK.
If you select the key which shows **********, go to o.
If you select a blank key, go to p.
o If you want to change the key you selected in n, press a or b to select Change. Press OK. Go to p.
If you want to keep the key you selected in n, press a or b to select Keep. Press OK. Go to s.
p Enter a new WEP key. Press OK. Go to s. (To manually enter the text, see Entering Text on page 112)
q Select the Encryption type, TKIP or AES using a or b. Press OK. Go to r.
r Enter the password and press OK. Go to s. (To manually enter the text, see Entering Text on page 112)
s The following will be displayed.
To apply the settings, select Yes. To cancel, select No.
If you select Yes, go to t.
If you select No, go back to h.
t The machine starts to connect to the wireless device you have selected.
u If your wireless device is connected successfully, the display shows Connected for 2 seconds and
configuration is completed.
If the connection failed, the display shows Connection Error for 2 seconds. See Wireless network
troubleshooting on page 99.