94
Cleaning the scanner C
a Turn off the machine’s power switch.
Disconnect all cables and then unplug
the power cord from the AC power
outlet.
b Lift the document cover (1).
Clean the white plastic surface (2) and
scanner glass (3) underneath it with a
soft lint-free cloth moistened with water.
c In the ADF unit, clean the white bar (1)
and the scanner glass strip (2)
underneath it with a soft lint-free cloth
moistened with water.
d Plug the machine’s power cord back into
the AC power outlet first, and reconnect
all cables. Turn on the machine’s power
switch.
Note
In addition to cleaning the scanner glass
and glass strip with a soft lint-free cloth
moistened with water, run your finger tip
over the glass to see if you can feel
anything on it. If you feel dirt or debris,
clean the glass again concentrating on
that area. You may need to repeat the
cleaning process three or four times. To
test, make a copy after each cleaning.
1
3
2
1
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
