Troubleshooting and routine maintenance
107
C
Checking the remaining life of
parts C
You can see remaining life of the machine’s
drum unit and periodic maintenance parts on
the LCD.
a Press Menu, 6, 7.
67.Parts Life
1.Drum
2.Fuser
3.Laser
Select ab or OK
b Press a or b to choose 1.Drum,
2.Fuser, 3.Laser, 4.PF Kit MP,
5.PF Kit 1 or 6.PF Kit 2
1
.
Press OK.
67.Parts Life
1.Drum
Remaining: XX%
1
PF Kit 2 appears only when the optional
LT-5300 tray is installed.
c Press Stop/Exit.
Note
The life check will be accurate only if you
have reset the drum counter when you
installed a new drum unit. It will not be
accurate if that part’s life counter was
reset during the life of the used part.
Reset C
The following reset functions are available:
1 Network
You can reset the print server back to its
default factory settings such as the
password and IP address information.
2 All Settings
You can reset all the machine settings
back to the settings that were set at the
factory.
Brother strongly recommends you use this
operation when you dispose of the
machine.
Note
Unplug the interface cable when you reset
All Settings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
