Troubleshooting and routine maintenance
109
C
f Put the drum unit and toner cartridge
assembly into a plastic bag and seal the
bag.
g Close the front cover.
h Put the styrofoam piece marked
“FRONT” into the original carton (1).
Pack the drum unit and toner cartridge
assembly (2) and put it in as shown
below (3). Wrap the machine in the
plastic bag and put it in the original
carton (4). Put the printed material
behind the machine (5).
i Put the two styrofoam pieces into the
carton matching. Match the front of the
machine to the “FRONT” mark on one of
the styrofoam pieces, and the back of
the machine to the “REAR” mark on the
other styrofoam piece (6). Put the AC
power cord and printed materials in the
original carton as shown below (7).
Note
If you are returning your machine to
Brother as part of the Exchange Service,
pack only the machine. Keep all separate
parts, including the drum unit and toner
cartridge assembly, and printed materials
to use with your ‘Exchange’ machine.
j Close the carton and tape it shut.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
