Brother DCP-J752DW

Chapter 3
10
NOTE
You can choose four different resolution
settings for monochrome faxes and two
for colour.
If you choose S.Fine or Photo and then
send a colour fax (choosing Colour in
Colour Setting), the machine will
send the fax using the Fine setting.
Setting your changes as a
new default 3
You can save the settings for the fax options
you use most often by setting them as the
default settings, such as Fax Resolution,
Contrast, Glass Scan Size,
Preview
1
, Real Time TX and
Colour Setting. These settings will
remain until you change them again.
1
MFC-J870DW only
a (MFC-J650DW)
Press (Fax).
(MFC-J870DW)
Do one of the following:
 When Fax Preview is set to Off,
press (Fax).
 When Fax Preview is set to On, press
(Fax) and then
(Sending Faxes).
b Press Options.
c Press a or b to choose the menu option
that you want to change. Press your new
option.
Repeat this step for each setting you
want to change.
d After changing the last setting to your
preferred option, press a or b to display
Set New Default.
e Press Set New Default.
f The Touchscreen asks you to confirm
the change to the new default settings.
Press Yes to confirm.
g Press .
Monochrome
Standard Suitable for most typed
documents.
Fine Good for small print and
transmits a little slower than
Standard resolution.
S.Fine Good for small print or artwork
and transmits slower than Fine
resolution.
Photo Use when the document has
varying shades of grey or is a
photograph. Photo has the
slowest transmission.
Colour
Standard Suitable for most typed
documents.
Fine Use when the document is a
photograph. The transmission
time is slower than Standard
resolution.