Brother DCP130C - Entry into the Maintenance Mode

9-1 Confidential
9.1 ENTRY INTO THE MAINTENANCE MODE
Press the Menu and Black Start (Mono Start) keys. Next press the key four times to make the
machine enter the maintenance mode.
The machine displays "
" on the LCD, indicating that it is placed in the
initial stage of the maintenance mode, a mode in which the machine is ready to accept entry from
the keys.
To select one of the maintenance-mode functions listed in Section 9.2, enter the corresponding 2-
digit function code using the
/ and OK keys on the control panel. (The details of each
maintenance-mode function are described in Section 9.4.)
NOTES • To exit from the maintenance mode and switch to standby, enter 9 twice using the
/
and OK keys in the initial stage of the maintenance mode.
• Pressing the Stop/Exit key after entering only one digit restores the machine to the
initial stage of the maintenance mode.
• If an invalid function code is entered, the machine resumes the initial stage of the
maintenance mode.