Brother DCP130C - List of Maintenance-Mode Functions

9-2 Confidential
9.2 LIST OF MAINTENANCE-MODE FUNCTIONS
Maintenance-mode Functions
Function
Code
Function
Reference
Section (Page)
01 EEPROM Parameter Initialization 9.4.1 (9-4)
05 Printout of Scanning Compensation Data 9.4.2 (9-5)
08 ADF Performance Test 9.4.3 (9-7)
09 Test Pattern 9.4.4 (9-8)
10 Firmware Switch Setting 9.4.5 (9-10)
11 Printout of Firmware Switch Data 9.4.5 (9-13)
12 Operational Check of LCD 9.4.6 (9-15)
13 Operational Check of Control Panel PCB
(Check of Keys)
9.4.7 (9-16)
32 Sensor Operational Check 9.4.8 (9-17)
54 Fine Adjustment of Scanning Start/End Position 9.4.9 (9-18)
55 Acquisition of White Level Data and CIS Scanner Area Setting 9.4.10 (9-19)
58 Updating of Paper Feeding Correction Value 9.4.11 (9-20)
59 Checking of CIS Travel and Specifying of CIS Type 9.4.12 (9-24)
63 Travel Check of the Head/Carriage Unit and Initial Setup Mode 9.4.13 (9-26)
65 Alignment of Vertical Print Lines in Monochrome 9.4.14 (9-27)
66 Margin Adjustment in Borderless Printing 9.4.15 (9-29)
68 Updating of Property Data 9.4.16 (9-32)
69 Head/Carriage Unit Traveling Speed Check 9.4.17 (9-33)
74 EEPROM Customizing 9.4.18 (9-34)
75 Travel of Head/Carriage Unit (for removing paper particles and
dust accumulated on the maintenance unit)
9.4.19 (9-36)
76 Purging Operation 9.4.20 (9-37)
80 Display of the Equipment's Log 9.4.21 (9-40)
82 Equipment Error Code Indication 9.4.22 (9-42)
88 Assurance Mode Switch Setting 9.4.23 (9-43)
91 EEPROM Parameter Initialization 9.4.1 (9-4)
99 Exit from the Maintenance Mode ----- (9-1)