Confidential
Appendix 3. EEPROM Customizing Codes
This appendix provides instructions on how to set up the EEPROM customizing codes for the
various preferences exclusively designed for each destination. The specified customizing code is
stored in the EEPROM mounted on the main PCB. If the main PCB is replaced, therefore, you
need to set up the proper customizing code with the machine in the maintenance mode.
NOTE: Customizing codes customize firmware for individual models, enabling the common
firmware to be used for various models. A list of EEPROM customizing codes comes with the
firmware data provided by Brother Industries.
Entering numerical codes
To enter numerical codes, press the / key several times to display the numerical code to be entered
and then press the OK key. Repeat this operation for each numerical code.
To Next Page
Loading...
