App. 4-25 Confidential
Selectors 8: Limitation on CNG detection
If this selector is set to "1," the machine detects a CNG signal according to the condition preset by
selectors 2 and 3 of WSW18 after a line is connected. If it is set to "0," the machine detects a CNG
signal as long as the line is connected.
WSW21 (TAD setting 1) (Not used.)
Selector
No.
Function Setting and Specifications
1
|
5
"No tone" detection period during
recording of ICM
(Max. waiting time for voice
signal)
No. 1 2 3 4 5
0 0 0 0 0 : No detection
0 0 0 0 1 : 1 sec.
0 0 0 1 0 : 2 sec.
0 0 0 1 1 : 3 sec.
| |
0 0 1 1 0 : 6 sec. (default)
| |
1 1 1 1 1 : 31 sec.
6
7
Taping the call
No. 6 7
0 0 : Enable (signaling for U.S.A.) (A)
0 1 : Enable (signaling for countries
except U.S.A.) (B)
1 0 : Enable (without signaling) (C)
1 1 : Disable (D)
8
Erasure of message stored in the
memory after the message
transfer
0: Yes 1: No
sec.: second(s)
NOTE: Selectors 1 through 5 are applicable to models equipped with ICM recorder.
NOTE: Selectors 6 through 8 are applicable to models with a built-in TAD.
Selectors 1 through 5: "No tone" detection period during recording of ICM (Max. waiting time for
voice signal)
If the machine detects "no tone"* during recording of ICM for the time length specified by these
selectors, it automatically stops recording ICM and disconnects the line. (*Tone whose level is less
than the threshold specified by selectors 1 through 3 on WSW33 is interpreted as "no tone.")
Selectors 6 and 7: Taping the call
These selectors select whether or not to tape the call. Setting them to "1, 0" enables taping the call
without signaling to the calling station that the call is being taped.
Selector 8: Erasure of message stored in the memory after the message transfer
Setting this selector to "0" will erase the message recorded in the memory after the document
retrieval feature transfers the message.
To Next Page
