Brother DCP130C - Page 342

App. 4-29 Confidential
WSW25
(TAD setting 3) (Not used.)
Selector
No.
Function Setting and Specifications
1
2
Delay time for starting "no tone"
detection in the external TAD
mode
No. 1 2
0 0: 0 sec.
0 1: 8 sec.
1 0: 16 sec.
1 1: 24 sec.
3
4
Threshold level of "no tone"
detection in the external TAD
mode
No. 3 4
0 0: -43 dB (A)
0 1: -46 dB (B)
1 0: -49 dB (C)
1 1: -51 dB (D)
5
|
7
Pause between paging number
and PIN
No. 5 6 7
0 0 0 : 2 sec.
0 0 1 : 4 sec.
0 1 0 : 6 sec.
0 1 1 : 8 sec.
1 0 0 : 10 sec.
1 0 1 : 12 sec.
1 1 0 : 14 sec.
1 1 1 : 16 sec.
8 Not used.
sec.: second(s)
NOTE: Selectors 1 through 4 are not applicable to the U.S.A. models, models without "no tone"
detecting function in the external TAD mode, or models with Rockwell modem V24.
NOTE: Selectors 5 through 7 are applicable to the U.S.A. models only.
 Selectors 1 and 2: Delay time for starting "no tone" detection in the external TAD mode
These selectors take effect only in the external TAD mode. The machine delays starting detection of
"no tone" by the time length specified by these selectors.
The total length of the delay time specified by these selectors and the maximum waiting time
specified by WSW21 (selectors 1 through 5) should not exceed 40 seconds.
 Selectors 3 and 4: Threshold level of "no tone" detection in the external TAD mode
These selectors specify the threshold level of "no tone" detection in the external TAD mode.
 Selectors 5 through 7: Pause between paging number and PIN
These selectors set the pause time between a telephone number being paged and PIN (personal
identification number) for the paging feature.