Brother GT-3 Series - Rear

2. Identifying Your Printer’s Parts
2-3. Rear
0045Y
No. Name Description
1 AC cord socket Inserts AC cord.
2 USB port Inserts USB cable to PC.
3 LAN port Inserts LAN cable to PC.
4 Rear Cover Covers the Platen moving area.
5 Waste Liquid Tube
Drains the waste ink.
Insert Waste Liquid Tube (2) and Tube Stopper (3) into Waste Ink Tank (1).
 Shorten the Waste Liquid Tube located inside the Waste Ink Tank to an
appropriate length (4 to 5 cm).
 Be careful so as not to bend the Waste Liquid Tube.
Otherwise, the waste liquid is less likely to flow.
0856D
6 Waste Ink Tank
Holds the waste ink. Be aware of the room.
 Discard the waste liquid before cleaning the tube.
(Or, check that the waste liquid amount is less than one half of the tank.)
If the Waste Liquid Tube soaks up the waste liquid, the liquid may leak from
the device side when cleaning the tube.
GT-3 Series
10