Brother HL-1112 - Resetting Drum Counter; Switching between Continue Mode and Stop Mode

4-3
Confidential
2. RESETTING DRUM COUNTER
By following this procedure after the drum unit has been replaced, the warning that appeared
when the drum unit was expiring or when it had reached the limit will be deactivated.
<Operating Procedure>
(1) Open the top cover while the machine is in the ready state. Press the button four
times to reset the drum counter.
3. SWITCHING BETWEEN CONTINUE MODE
AND STOP MODE
This function is to change the toner setting to continuous printing mode (allows you to use the
current toner cartridge even when the LED is prompting toner replacement) or stop mode
(default).
<Operating Procedure>
(1) Press the button seven times while the machine is in the ready state.
All LEDs flash twice when continue mode is set (ON 1 sec. / OFF 1 sec.)
All LEDs flash once when toner stop mode is set (ON 1 sec.)