HL-2030/2040/2070N SERVICE MANUAL
Confidential
2-19
Manual duplex printing from the manual feed slot
NOTE:
You should not use very thin or very thick paper.
!
CAUTION:
* Before you put the sheets back in the manual feed slot, you will have to straighten them, or
you may get paper jams.
* You should not use very thin or very thick paper.
* When you use the manual duplex function, it is possible that there may be paper jams or poor
print quality. If there is a paper jam, see 4. PAPER PROBLEMS in Chapter 7.
(1) From Advanced tab choose the Manual Duplex printing mode, and from the Basic tab
choose the Paper Source to be Manual feed.
(2) Using both hands put the paper in the manual feed slot with the side that is going to be
printed on first facing up. Follow the instructions on the computer screen. Repeat this step
until you have printed all the even-numbered pages.
Fig. 2-19
(3) Remove the printed even-numbered pages from the output tray and put them into the
manual feed slot in the same order. Place the paper with the side that is going to be
printed on (the blank side) face up. Follow the instructions on the computer screen.
Fig. 2-20
(4) Repeat Step (3) until you have printed all the odd-numbered pages on the other side of the
paper.
To Next Page
Loading...
