Embroidering
70
Split embroidery patterns
Split embroidery patterns created with PE-DESIGN Ver.7 or
later, or PE-DESIGN NEXT can be embroidered. With split
embroidery patterns, embroidery designs larger than the
embroidery hoop are divided into multiple sections, which
combine to create a single pattern after each section is
embroidered.
For details on creating split embroidery patterns and for more
detailed embroidery instructions, refer to the Instruction
manual included with PE-DESIGN Ver.7 or later, or PE-
DESIGN NEXT.
a
Insert the USB flash drive containing the created split
embroidery pattern, and then select the split
embroidery pattern to be embroidered.
• For details, refer to “Retrieving embroidery patterns”
on page 75.
b
Select section to be embroidered and press .
• Select the sections in alphabetical order.
c
Press and press .
d
Press the “Start/Stop” button to embroider the pattern
section.
e
When embroidering is finished, the following screen
appears. Press .
→ A screen appears so that a section of the split
embroidery pattern can be selected.
f
Repeat steps b through e to embroider the
remaining sections of the pattern.
To Next Page
Loading...
