Brother MFC-6800 - Remote Retrieval Access Card

REMOTE RETRIEVAL ACCESS CARD R - 1
Remote Retrieval Access Card
If you plan to receive fax messages while away from your machine, carrying the
Remote Retrieval Access Card printed below will serve as a convenient
reminder of the retrieval procedures. Simply cut out the card and fold it to fit
your wallet or organizer. Keeping it handy will help you derive the full benefit
of your machine’s forwarding, paging and remote retrieval features.
Using Remote Retrieval Access Code
1
Dial your fax number from a fax machine using touch tone.
2
When your MFC answers, immediately enter your Remote Retrieval Access Code (159 ).
3
Your MFC signals the kinds of messages received:
1 long beep — Fax message(s) No beeps — No messages.
4
After 2 short beeps, enter a command.
5
Press
9 0
to reset your MFC when you finish.
6
Hang up.
1
4
Press
9 7 1
1 long beep — Fax message(s) 3 short beeps — No messages
CHANGE ANSWER MODE Press
9 8
then for EXT.TEL/TAD, press
1
.
FAX ONLY, press
2
.
EXIT REMOTE OPERATION Press
9 0
.
CHECK RECEIVING STATUS
R
EMOTE
R
ETRIEVAL
A
CCESS
C
ARD
Fold Fold