Brother MFC-7220 - Page 106

Confidential
5-37
NOTE: When re-assembling the chute base, check that the bind B M4x12 taptite screws (A)
and (B) shown in the figure above are secured correctly.
<How to check>
Check that the distance between the floor and the separation roller collar of the pickup roller
holder ASSY is 45.5 to 47.5mm by using the plate jig. If not, re-assemble the chute base.
B
A
47.5mm
More than 47.5mm
45.5mm
Less than 45.5mm
Separation roller colla
r
Floo
r
Plate jig
47.5m
m
45.5m
m
[A] is contacted with the roller.
[B] is not contacted with the roller.
<Plate jig>
45.5 to 47.5m
m
Pickup roller holder ASSY
(Separation roller)
Plate jig
Pickup roller holder ASSY
(Separation roller)