Brother MFC-7220 - 10 ] Inputting the Adjusted Value of the Laser Scanner; 11 ] Switch Back to Standby

6-3 Confidential
[ 10 ] Inputting the adjusted value of the laser scanner
(1) Select ‘Adjust Scanner’ from Menu.
(See step1 of the left illustration)
(2) Look for the laser unit serial label which
can be found on the right of the main
PCB. (Refer to the NOTE below for the
laser unit serial label)
(3) Enter the last 4 digit numbers of the
machine.
(See step3 of the left illustration)
(4) Then click the OK button.
NOTE: Please refer to the illustration below for the identification and the location of the
laser unit serial label.
NOTE: The error of “NG!!” may be shown after the input of the adjusted value but the entry
should be accepted correctly.
[ 11 ] Switch back to standby
Disconnect the USB cable and press the 9 key twice.
Step (1)
Step (3)
Laser unit serial label
Laser unit serial label
Enter the last 4 digits shown on the label