Confidential
5-47
(2) Remove the two pan M3x6 screws.
(3) Remove the CDCC PCB from main frame L.
(4) Disconnect the CDCC PCB harness.
NOTE:
• When replacing the main PCB, refer to ‘ADJUSTMENTS AND UPDATING OF
SETTINGS, REQUIRED AFTER PARTS REPLACEMENT’ in Chapter 6.
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check that
the cables are not at an angle.
(5) Remove the five cup S M3x6 taptite screws and FG harness ASSY 6.
(6) Remove the main PCB from main frame L.
Main PCB
Screws, Pan M3x6
CDCC PCB harness
Main frame L
Taptite, cup S M3x6
Taptite, cup S M3x6
FG harness ASSY 6
Main frame L
Main PCB
CDCC PCB
To Next Page
Loading...
