Confidential
9-2
ERROR MESSAGE CAUSE ACTION
Print data is left in the machine’s
memory.
Re-start printing from your computer. Data Remaining
(For MFC-7220/7225N only)
Print data is left in the machine’s
memory. The USB cable was
unplugged while the computer was
sending the data to the machine.
Press Job Cancel. The machine will
cancel the job and clear it from the
memory.
Disconnected The other person or other person’s
fax machine stopped the call.
Try to send or receive again.
Clean the corona wire. Dust on Drum The drum unit needs to be
cleaned.
Clean the electrodes of the main body
and drum unit.
(Refer to “Location of Grounding
Contacts” in this chapter.)
DR Mode in Use The machine is set to Distinctive
Ring mode. You can not change
the Receive Mode from Manual to
another mode.
Set Distinctive Ring to Off.
Unit is too Hot The fixing unit is too hot.
Fail to Warm up The fixing unit is too cold.
(For FAX-2820/2825 and MFC-7220)
When you turn off the machine’s
power switch its memory will be
cleared. If there are faxes, you need to
save them before following the
suggestions below.
Then, turn off the machine’s power
switch. Check the machine’s
environment. If it is in a location that
is too hot or too cold, try to cool or
warm the room by turning on the air
conditioner or heater. Or, move the
machine to another location. Then,
turn on the machine power switch.
(For FAX-2910, FAX-2920 and MFC-
7225N)
Turn off the machine’s power switch,
and check the machine’s environment.
If it is in a location that is too hot or
too cold, try to cool or warm the room
by turning on the air conditioner or
heater. Or, change the location. Then,
turn on the machine’s power switch.
(The machine can be turn off for up
to 4 days without losing faxes stored in
the memory.)
To Next Page
Loading...
