Troubleshooting and routine maintenance
141
C
Registration Registration failed. Press Mono Start or Color Start and try
again.
Do one of the following:
Turn off the machine’s power switch.
Wait a few seconds, then turn it on again.
Try Manual Registration, Menu, 4, 7.
(See Manual Registration on page 160.)
Put in a new belt unit. (See Replacing the
belt unit on page 172.)
If the problem continues, call your
Brother dealer.
Rename the File
(MFC-9320CW only)
There is already a file on the USB
Flash memory drive with the
same name as the file you are
trying to save.
Change the file name of the file on the USB
Flash memory drive or the file you are trying
to save.
Replace Belt It is time to replace the belt unit. Replace the belt unit. (See Replacing the
belt unit on page 172.)
Replace Drums It is time to replace the drum
units.
Replace the drum units.
(See Replacing the drum units on page 169.)
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter.
(See
Resetting the drum counter
on page 172.)
Replace Drum(X)
1
It is time to replace the drum unit
for the indicated color.
Replace the drum unit for the color indicated
on the LCD.
(See Replacing the drum units on page 169.)
Replace Fuser It is time to replace the fuser unit. Call your Brother dealer to replace the fuser
unit.
Replace PF Kit It is time to replace the paper
feeding kit.
Call your Brother dealer to replace the
PF Kit.
Replace Toner The toner cartridge is at the end
of its life.
Replace the toner cartridge for the color
indicated on the LCD. (See Replacing a
Toner cartridge on page 163.)
Replace WT Box It is time to replace the waste
toner box.
Replace the waste toner box. (See
Replacing the waste toner box on page 176.)
Scan Unable XX
(XX = Enter Code)
The machine has a mechanical
problem.
Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
60 hours without losing faxes stored in
the memory. See Transferring your faxes
or Fax Journal report on page 143.)
If the problem continues, call Brother
Customer Service.
Error Message Cause Action
To Next Page
Loading...
