Brother MFC-9320CW - Page 150

140
Out of Memory The machine’s memory is full. Fax sending or copy operation in
progress
Do one of the following:
 Press Mono Start or Color Start to send
or copy the scanned pages.
 Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
 Clear the data from the memory. (See
Out of memory message on page 43 or
page 87.)
Print operation in process
Do one of the following:
 Reduce print resolution. (See Advanced
tab in the Software User’s Guide on the
CD
-ROM.)
 Clear the faxes from the memory. (See
Out of memory message on page 87.)
Print Unable XX
(XX = Enter Code)
The machine has a mechanical
problem.
Do one of the following:
 Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
60 hours without losing faxes stored in
the memory. See Transferring your faxes
or Fax Journal report on page 143.)
 If the problem continues, call your
Brother dealer.
Print Unable 1A One of the issues that can cause
this error is that condensation
may form inside the machine after
a room temperature change.
Turn the power switch off and fully open the
top cover. Leave the machine off and open
for 30 minutes to remove any condensation
from inside the machine, then close the top
cover and turn the machine on again. If this
does not clear the error, call your dealer or a
Brother Customer Service.
Protected Device
(MFC-9320CW only)
The protect switch of the USB
Flash memory drive is on.
Turn off the protect switch of the USB Flash
memory drive.
Error Message Cause Action