Dialling and storing numbers
15
5
Setting up groups for
broadcasting 5
Groups, which can be stored in a Speed Dial
location, allow you to send the same fax
message to many fax numbers by pressing
only (Speed Dial), Search, OK,
the two-digit location and Mono Start.
First, you'll need to store each fax number in
a Speed Dial location. Then you can include
them as numbers in the Group. Each Group
uses up a Speed Dial location. You can have
up to six Groups, or you can assign up to
39 numbers in a large Group.
(See Broadcasting (Monochrome only)
on page 8 and Storing Speed Dial numbers in
chapter 7 in the Basic User’s Guide.)
a Press (Speed Dial).
b Press a or b to choose Setup Groups.
Press OK.
c Press a or b to choose GROUP1,
GROUP2, GROUP3, GROUP4, GROUP5 or
GROUP6 for the Group name where you
will store the fax numbers.
Press OK.
d Press a or b to choose the two-digit
Speed Dial location you want to add to
the Group.
Press OK.
e Press a or b to choose Add Number.
Press OK.
f To add numbers to the group, press
a or b to choose
Alphabetical Order or
Numerical Order and OK. Press
a or b to select a number and OK.
g Do one of the following:
To add another number to the group,
repeat steps e to f.
If you are finished adding numbers to
the group, press a or b to choose
Complete.
Press OK.
h Do one of the following:
To store another Group for
broadcasting, repeat steps c to g.
To finish storing Groups for
broadcasting, press Stop/Exit.
You can print a list of all the Speed Dial
numbers. Group numbers will be marked
in the GROUP column. (See Reports
on page 18.)
To Next Page
Loading...
