Chapter 8
38
• If Remove Red-Eye appears on the LCD,
press # to attempt to remove red-eye from
your photo.
• Press Clear to undo the effect.
e Press OK and enter the number of
copies you want using the dial pad.
f Do one of the following:
Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 42.)
If you do not want to change any
settings, press Colour Start to print.
Enhance Skin-Tone
8
Enhance Skin-Tone is best used for adjusting
portrait photographs. It detects human skin
colour in your photos and adjusts the image.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose Enhance Skin.
Press OK.
e Do one of the following:
Press OK if you do not want to
change any settings.
Press a or b to adjust the effect level
manually.
Press OK when you have finished.
f Enter the number of copies you want
using the dial pad.
g Do one of the following:
Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 42.)
If you do not want to change any
settings, press Colour Start to print.
Enhance Scenery 8
Enhance Scenery is best used for adjusting
landscape photographs. It highlights green
and blue areas in your photo, so that the
landscape looks more sharp and vivid.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Enhance Scenery.
Press OK.
e Do one of the following:
Press OK if you do not want to
change any settings.
Press a or b to adjust the effect level
manually.
Press OK when you have finished.
f Enter the number of copies you want
using the dial pad.
g Do one of the following:
Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 42.)
If you do not want to change any
settings, press Colour Start to print.