Brother MFC-J6520DW

112
Document Jam/too Long The document was not inserted or fed
correctly, or the document scanned
from the ADF was too long.
(See Using the ADF on page 44.)
(See Document jam on page 121.)
DR Mode in Use
(For Australia, Singapore
and Hong Kong)
FaxAbility On
(For New Zealand)
(For Australia, Singapore and Hong
Kong)
The machine is in Distinctive Ring
mode. You cannot change the
Receive Mode from Manual to
another mode.
(For New Zealand)
The machine is in FaxAbility mode.
You cannot change the Receive
Mode from Manual to another mode.
(For Australia, Singapore and Hong
Kong)
Set Distinctive Ring to Off.
(See Turning off Distinctive Ring
on page 65 and 70.)
(For New Zealand)
Set FaxAbility to Off.
(See How to Turn FaxAbility OFF or
ON on page 67.)
High Temperature The room temperature is too high. After lowering the room temperature,
allow the machine to cool down to
room temperature. Try again later.
Hub is Unusable. A hub or USB Flash drive with hub
has been connected to the USB direct
interface.
Hubs, including USB Flash drives
with built-in hubs, are not supported.
Unplug the device from the USB
direct interface.
Image Too Long The proportions of your photo are
irregular so effects could not be
added.
Choose a regularly proportioned
image.
Image Too Small The size of your photo is too small to
trim.
Choose a larger image.
Error Message Cause Action