Error Message Cause Action
No Paper
The machine is out of
paper, or paper is not
loaded correctly in the
paper tray.
Do one of the following:
• Refill paper in the paper tray. Make
sure the paper guides are set to
the correct size.
• Remove the paper and load it
again. Make sure the paper guides
are set to the correct size.
• Make sure not to overfill the paper
tray.
No Toner
The toner cartridge is not
installed or is not installed
correctly.
Remove the drum unit and toner
cartridge assembly. Install the toner
cartridge in the drum unit correctly.
Reinstall the toner cartridge and drum
unit assembly in the machine. If the
problem continues, replace the toner
cartridge.
Print Unable XX The machine has a
mechanical problem.
• (MFC-L2700D/MFC-L2701D/
MFC-L2700DW/MFC-L2701DW/
MFC-L2703DW)
To prevent you from losing the
received fax data in the machine's
memory, transfer the data to
another Fax machine or to your
computer before turning off the
machine.
• Press and hold to turn off the
machine, wait a few minutes, and
then turn it on again.
• If the problem continues, contact
Brother customer service.
Replace Drum
It is time to replace the
drum unit.
Replace the drum unit.
The drum unit counter was
not reset when a new drum
was installed.
Reset the drum unit counter.
See the instructions included with the
new drum unit.
Replace Toner
The toner cartridge is at the
end of its life. The machine
stops all print operations.
While memory is available,
faxes are stored in the
memory.
Replace the toner cartridge with a
new one.
Scan Unable
The document is too long
for 2‑sided scanning.
Press Stop/Exit. Use an appropriate
size paper for 2‑sided scanning.
46
To Next Page
Loading...
Need help?
General
