5-50
Confidential
*1
01 to 10 will be displayed for "##" in chronological order. Pressing the [SET] or [OK] key
while the machine error log is displayed shows "PGCNT:00000000" (total pages printed at
the time of the error) on the LCD.
*2
The serial number can be changed according to the procedures below.
*3
For models without fax, the LCD displays "TTLLIST:00000000" (List pages printed).
*4
Pressing the [SET] or [OK] key while the replacement count by consumables is displayed
shows "DATE_XX:000000" (XX: name of consumables) and the date of replacement on the
LCD. (Models without RTC does not display the replacement date.)
*5
Pressing the [SET] or [OK] key while the communication error is displayed shows
"DATE:0000000000" and the date of replacement on the LCD. (Models without RTC does
not display the replacement date.)
*6
01 to 10 will be displayed for "##" in chronological order. Pressing the [SET] or [OK] key
while the machine error log is displayed shows "TM:00000 BT:000" (TM: minutes passed
from the previous error, BT: number of times that the power is turned ON/OFF) on the LCD.
*7
01 to 10 will be displayed for "##" in chronological order. Pressing the [SET] or [OK] key
while the log for design analysis is displayed shows "PGCNT:00000000" (total pages printed
at the time of the error) on the LCD.
For models without keypad
1) Press the [▲] or [▼] key while the
serial number is displayed to
display "9" on the LCD, and press
the [OK] key. LCD displays the
serial number again.
2) Enter the [4], [7] and [5] in this order
as described in the procedure (1).
Serial number is displayed on the
LCD. The first digit starts flashing to
indicate that it is editable.
3) Press the [▲] or [▼] key to display
the first digit of the serial number on
the LCD, and press the [OK] key.
The second digit starts to flash.
Enter the second digit to the 15th
digit similarly.
4) Press the [OK] key, and the serial
number is saved. The machine
returns to the initial state of
maintenance mode.
For models with keypad
1) While the serial number is
displayed, press the [9], [4], [7], and
[5] keys in this order. The first digit
of the serial number starts flashing
to indicate that it is editable.
2) Use the keypad to enter the first
digit of the serial number. The
second digit starts to flash. Enter
the second digit to the 15th digit
similarly.
<Entry method of alphanumeric
characters>
See the table below and press the
corresponding key until the desired
character is displayed.
3) Press the [SET] or [OK] key, and
the serial number is saved. The
machine returns to the initial state
of maintenance mode.
Keypad Assigned characters
2 2→A→B→C
3 3→D→E→F
4 4→G→H→I
5 5→J→K→L
6 6→M→N→O
7 7→P→Q→R→S
8 8→T→U→V
9 9→W→X→Y→Z
To Next Page
Loading...
Need help?
General
Weight and Dimensions
