Troubleshooting
67
B
Out of Memory The machine's memory is full. If a fax-sending or copy operation
is in process:
Press Detener/Salir (Stop/Exit)
and wait until the other operations
in process finish, and then try
again.
Press Inicio Negro (Black Start)
to send the pages scanned so far.
Press Inicio Negro (Black Start)
or Inicio Color (Color Start) to
print the pages scanned so far.
Clear the data in the memory. To
gain extra memory, you can turn
off Memory Receive.
(See Advanced User’s Guide:
Turning off Memory Receive
operation.)
Print the faxes that are in the
memory. (See Advanced User’s
Guide: Printing a fax from the
memory.)
Paper Jam The paper is jammed in the machine. Remove the jammed paper by
following the steps in Printer jam or
paper jam on page 71.
Make sure the paper length guide is
set to the correct paper size. DO NOT
extend the paper tray when you load
A5 or smaller size paper.
If there is a repeat paper jam, a small
piece of paper may be stuck in the
machine. Make sure paper is not still
jammed in the machine. (See
Additional paper jam clear operations
on page 74.)
Paper dust has accumulated on the
surface of the paper pick-up rollers.
Clean the paper pick-up rollers.
(See Advanced User’s Guide:
Cleaning the paper pick-up rollers.)
Error Message Cause Action
To Next Page
Loading...
Need help?
General
