Brother MFC5890CN - Lubrication

6-85
Confidential
6.2 LUBRICATION
Apply the specified lubricants to the lubrication points as shown below.
 Head/carriage unit
Apply a 1.5 mm diameter ball of grease (Permalub BAN-5) to the lubrication points below.
Lubricant type
(Manufacturer)
Lubrication points
No. of
points
Lubricant amount
per point
Permalub BAN-5
(Nippon Koyu)
Head/carriage unit 3 1.5 mm diameter ball
Motor plate and CR guide rail
(bottom edges)
4
1 mm diameter ball
Switching lever guide 1 3 mm diameter ball
FLOIL BG1319
(Kanto Kasei)
CR guide rail (upper face) 11 2 mm diameter ball
CR support chassis (upper face) 11
CR support chassis (front and rear
sides of upright rear edge)
28
Molykote EM-30LP
(Dow Corning)
Paper pull-in idle gear 1 3 mm diameter ball
Paper pull-in roller L 2 1 mm diameter ball
Head/carriage unit
(6_84)
Apply grease here.