6-35
Confidential
6.1.8 Ink Cartridge Cover and Media Module Cover
(1) Open the ink cartridge cover fully, warp its center upward as shown below, pull its left edge
to release the left boss from the lower cover and then remove the ink cartridge cover.
(2) Release the left and right lock arms of the media module cover and pull the cover to the
front.
Assembling Note: When mounting the ink cartridge cover, first insert the cover arm into
the slit provided in the right side of the lower cover and fit the right boss into the right hole
in the lower cover. Then warp the center of the ink cartridge cover upward as shown above
and fit the left boss into the left hole.
Slit
Lock arm
Cover arm
Boss
Boss
Lower cover
Lock arm
Media module cover
Ink cartridge cover
(6_38)
Boss
Retainer
To Next Page
Loading...
