Brother MFC5890CN - Chapter 7 Adjustments and Updating of Settings, Required after Parts Replacement

Confidential
CHAPTER 7 ADJUSTMENTS AND UPDATING OF SETTINGS,
REQUIRED AFTER PARTS REPLACEMENT
This chapter details adjustments and updating of settings, which are required if the head/carriage unit,
main PCB and some other parts have been replaced.
CONTENTS
7.1 PREPARATION ......................................................................................................7-1
7.1.1 Requirements............................................................................................7-1
7.1.2 Installing the Maintenance USB Printer Driver..........................................7-3
7.2 IF YOU REPLACE THE HEAD/CARRIAGE UNIT OR ENGINE UNIT...................7-7
[ 1 ] Update the head property information stored in the EEPROM
on the main PCB...............................................................................7-7
[ 2 ] Clean the new head/carriage unit (Function code 76) ......................7-10
For the head/carriage unit having a round, blue seal* ......................7-10
For the head/carriage unit having no seal.........................................7-10
[ 3 ] Print out a test pattern (Function code 09)........................................7-11
[ 4 ] Correct the positioning error of the head/carriage unit......................7-12
[ 5 ] Update the paper feeding correction value (Function code 58) ........7-15
[ 6 ] Align vertical print lines (Function code 65) ......................................7-19
[ 7 ] Adjust margins in borderless printing (Function code 66).................7-21
[ 8 ] Print out a total check pattern ...........................................................7-26
[ 9 ] Switch back to standby .....................................................................7-28
[ 10 ] Replace the ink cartridges with the protective part ...........................7-28
7.3 IF YOU REPLACE THE MAIN PCB .......................................................................7-29
[ 1 ] Load update programs/data..............................................................7-29
[ 2 ] Initialize the EEPROM on the main PCB (Function code 01) ...........7-29
[ 3 ] Customize the EEPROM on the main PCB (Function code 74) .......7-29
[ 4 ] Specify the LCD type (For models with 3.3-inch LCD)
(Function code 12) ............................................................................7-29
[ 5 ] Specify the CIS type (Function code 59)...........................................7-29
[ 6 ] Check the control panel PCB for normal operation
(Function code 13) ............................................................................7-29
[ 7 ] Check the sensor operation (Function code 32) ...............................7-29
[ 8 ] Acquire white level data and set CIS scanner area
(Function code 55) ............................................................................7-29
[ 9 ] Set an ID code and update the head property information ...............7-29
[ 10 ] Back up machine information (Function code 46).............................7-31