Brother MFC5890CN - Page 325

9-33
Confidential
-- Specify the CIS type --
Note: Before proceeding to the CIS type specification procedure, be sure to update the
firmware to the latest version. Otherwise, an error may occur.
(1) Open the scanner cover and check the CIS type shown on the bar code label.
(2) Press the 5 and 9 keys in this order in the initial stage of the maintenance mode.
The "1:MO 2:CO 3:CHG?" appears on the LCD.
(3) To call up the CIS type menu, press the 3 key.
(The "1:MO" is for checking the CIS travel, as described on the previous page. The "2:CO"
is for checking scanning clocks at the factory, so do not access it.)
The "CIS TYPE SET" appears on the LCD.
(4) Check the particular code in the bar code label as specified above.
If the code is "G,"
press the 0 key; if "H," press the 2 key; if "M," "R," "S" or "No bar code
label," press the 1 key. The machine returns to the initial stage of the maintenance mode.
Bar code label
(CIS_Label_BHL9_A3_E)
G
H
Press 0 key.
Press 2 key.
M, R, S, No bar code label Press 1 key.