Home > Paper Handling > Load Paper > Paper Settings > Change the Check Paper Setting
Change the Check Paper Setting
If this setting is set to [On] and the paper tray is removed, the LCD displays a message asking if you want to
change the Paper Size and Paper Type settings.
The default setting is [On].
>> MFC-J4340DW
>> MFC-J4440DW/MFC-J4540DW
MFC-J4340DW
1. Press Settings.
2. Press a or b to make your selections:
a. Select [General Setup]. Press OK.
b. Select [Check Paper]. Press OK.
c. Select [On] or [Off]. Press OK.
3. Press Stop/Exit.
MFC-J4440DW/MFC-J4540DW
1. Press [Settings] > [All Settings] > [General Setup].
2. Press [Tray Setting]. (MFC-J4540DW)
3. Press a or b to display the [Check Paper] option, and then press it.
4. Press [On] or [Off].
5. Press .
Related Information
• Paper Settings
Related Topics:
• Load Cut-Sheet Paper or Photo Paper in the Paper Tray #1 / Paper Tray #2
• Load Envelopes in the Paper Tray #1
• Error and Maintenance Messages
47
To Next Page
Loading...
