Set Up Your Label Printer
4
Insert the Ribbon Cassette or Tape Cassette 2
a Place your fingers on the Tape Exit Slot,
as shown.
b Open the Cassette Cover by pulling the Tape
Exit Slot to the left.
c Insert the Ribbon/Tape Cassette following the
drawing marked inside the case. Confirm that
the tip of the ribbon/tape is pointed at the Tape
Exit Slot.
d Press the Ribbon/Tape Cassette into the
label printer until it locks into place and close
the Cassette Cover.
• After the ribbon/tape passes under the Tape
Guide, pull the tip to remove any slack in the
ribbon/tape.
• Make sure the ribbon/tape is not caught in the
unit when inserting or removing the Tape
Cassette.
To Next Page
Loading...
