Brother P-Touch PT-2730 - Write Serial No. Mode ([U] Key)

III - 63
3.3.7 Write serial No. mode ([U] key)
Press the [U] key from the state of “Figure 3.2-1”, and the current USB ID will be
displayed. (Figure 3.3-39)
Figure 3.3-39
In this state, display the “Figure 3.3-40” by pressing the [2], [7], [3] and [0] keys in this
order. And the edit of USB ID becomes possible.
Figure 3.3-40
The input type is the extrusion system, and the available characters are A to Z and 0
to 9.
Enter 9 digits of the machine serial number attached on the bottom of the machine.
Write the USB ID in the FROM by pressing the below key. After writing, return to the
“Figure 3.2-1”.
* Europe/North America specifications: [OK] / [ENTER]
If press the below key before writing the new USB ID in the FROM, delete the entered
contents and return to the “Figure 3.3-40”.
* Europe/North America specifications: [Space]
USB ID DSP
B00000001
USB ID SET
B00000001