GETTING STARTED
26
Power Supply
Alkaline/Ni-MH Battery
After making sure that the power is off, remove the rear cover
on the back of the P-touch labeling system. If the batteries
are already in the P-touch labeling system, remove them.
Insert six new AA-size alkaline batteries (LR6), or fully
charged Ni-MH rechargeable batteries (HR6), making sure
that the positive (+) and negative (-) ends of the batteries
match the positive (+) and negative (-) marks inside the
battery compartment.
Users of alkaline batteries
23
Users of Ni-MH rechargeable batteries
Attach the rear cover by inserting the three hooks at the
bottom into the slots on the P-touch labeling system, then
pushing down firmly until it snaps into place.
Make sure that the power is turned off when replacing
batteries.
Always replace all six batteries at the same time using brand
new ones.
Always replace all six batteries at the same time with fully
charged ones.
Visit us at http://solutions.brother.com/ for the latest
information about recommended batteries.
• Remove the batteries if you do not intend to use the P-touch labeling system for an extended
period of time.
• Dispose of the battery at an appropriate collection point, not in the general waste stream. In
addition, be sure to observe all applicable federal, state, and local regulations.
• When storing or discarding the battery, wrap it (for example with
cellophane tape), to prevent it from short-circuiting.
(Battery insulation example)
1. Cellophane tape
2. Alkaline or Ni-MH battery
To Next Page
Loading...
Need help?
General
Weight and Dimensions
