BRP Evinrude E-TEC Series Installation Manual

70
OUTBOARD RIGGING
EVINRUDE E-TEC MODELS 40–90 HP
Use Evinrude Diagnostics software to adjust net-
work settings in th e EMM. From the Settings
screen, select Engine Options.
Water Pressure Gauge
To display engine water pre ssure, in stall a water
pressure hose fitting in th e cylind er block as
shown.
Use Pipe Sealant with Teflon on the threads of the
hose fitting. Refer to inst allation instructions su p-
plied with gauge.
For an I-Command water pressure display , sev-
eral water p ressure senso r kit s are a vailable.
Refer to the Evinrude/Johnson Genuine Parts
and Accessories catalog.
Engine Options Screen 008563A
1. Fitting 002461
1

BRP Evinrude E-TEC Series Specifications

General

Engine Type	2-Stroke
Fuel System	Direct Injection
Horsepower Range	25 HP - 300 HP
Starting System	Electric Start
Cooling System	Water Cooled
Shaft Length	15", 20", 25"
Gear Ratio	Varies by model
Emissions Compliance	EPA, CARB
Warranty	3-Year
Alternator Output	Varies by model (e.g., 300 HP: 133A)
Cylinder Configuration	Inline or V (varies by model)