INSTALLATION24
5
Do not smoke near the battery when the
battery is charging.
Do not charge the battery when the
electrolyte level is low. Otherwise, the
battery will be damaged and may cause
malfunction.
ENOW00014-0
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
The starter motor may fail to operate if
the leads are incorrectly connected.
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system
will be damaged.
Do not disconnect the battery leads
from battery while the engine is operat-
ing, the electrical parts could be dam-
aged.
Always use a fully charged battery.
ENOW00015-0
Do not use a battery that is not recom-
mended. Use of a bat tery not recom-
mended can lead to poor performance of,
and/or damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 70AH/5HR,
650 (Cold Cranking Amps (CCA), In case of
cold whether: 12V100AH/5HR (850CCA))
Specifications and features of batteries vary
among the manufacturers. Consult the
manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the outboard
motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery, and
then connect the negative lead (—).
Wh en disc onn ect ing th e b att ery
always remove the negative lead (—)
first. After connecting the positive ter-
minal (+), securely place a cap on it to
prevent short circuits.
1. Battery cord (red)
2. Battery cord (black)
ENOM00971-A
When engine operates at high altitude
engine may need to have a high altitude kit
installed. Otherwise, operating the engine
at high altitude may increase its emissions
and decrease fuel efficiency and perfor-
mance. Contact authorized
BRP dealer for
more detail.
CAUTION
CAUTION
4. Altitude adjustment kit
installation
E15__US_EN_141125N.book 24 ページ 2014年12月26日 金曜日 午後2時46分