BRP EVINRUDE E15R4 - Starting the Engine

ENGINE OPERATION 33
7
1. Full open the air vent screw on the fuel
tank cap.
1. Air vent screw
2. Fuel tank cap
2. Loosen the tank cap until it contacts
the tab lock and release internal pres-
sure completely. After that, close the
tank cap until two clicks sound is
heard.
3. Connect the fuel connector to the
engine and fuel tank.
1. Fuel connector
2. Push
3. Insert
1. Pull
2. Insert
4. Squeeze primer bulb until it becomes
stiff to feed fuel to vapor separator.
Direct arrow mark upward when prim-
ing.
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb with engine
running or when the outboard motor is
tilted up. Otherwise, fuel could overflow.
ENOM00045-B
ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump
damage, be sure the water level is at least
10 cm (4 in.) above the anti ventilation
plate.
1
2
ENOF00421-0
1
2
2
3
3
ENOF00311-0
2. Starting the engine
CAUTION
1
2
ENOF00861-A
1
2
ENOF00862-0
E15__US_EN_141125N.book 33 ページ ２０１４年１２月２６日 金曜日 午後２時４６分