BRP EVINRUDE E15R4 - Engine Oil Recommendation

PRE-OPERATING PREPARATIONS 27
6
1. Air vent screw
2. Tank cap
2. Loosen the tank cap until it contacts
the tab lock and release internal pres-
sure completely. After that, press
down the tab lock and open the tank
cap.
3. Fill the fuel carefully not to over flow.
4. After filling the tank, close the fuel tank
cap until two clicks sound is heard.
ENOM00037-A
ENOW00022-A
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions, See page 58)
Use only high quality 4-stroke engine oil to
insure performance and prolonged engine
life.
The SAE oil viscosity 10W-30 or 10W-40
FC-W outboard motor engine oil is recom-
mended.
You can also use oils that carry the API
rating of SH, SJ, or SL. Select the appro-
priate viscosity, based on atmospheric
temperature, from the chart below.
ENOW0002A-A
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
3. Engine oil recommendation
CAUTION
1
2
ENOF00421-0
SAFE FILL
LEVEL
12 L
NIVEAU
MAXIMUM
ENOF00419-A
CAUTION
ENOF01209-0
10W−40
10W−30
˚C
˚F
40
96
30
86
20
68
10
50
0
32
-10
14
-20
-4
-30
-22
ENOF00208-0
E15__US_EN_141125N.book 27 ページ ２０１４年１２月２６日 金曜日 午後２時４６分