BRP EVINRUDE E15R4 - Warming Up the Engine; Forward, Reverse, and Acceleration

ENGINE OPERATION 39
7
ENOM00043-B
ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 41°F (5 ℃ )
5 minutes at 2000 rpm : below 41°F (5 ℃ )
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 rpm
for several minutes.
ENOM00046-A
ENOW00037-0
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
 Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
3. Warming up the engine
CAUTION
ENOF00320-0
ENOF00321-0
Clutch in (In gear) Clutch off (Out of gear)
900 rpm 950 rpm
4. Forward, reverse, and
acceleration
WARNING
WARNING
ENOF01212-0
E15__US_EN_141125N.book 39 ページ ２０１４年１２月２６日 金曜日 午後２時４６分